Car Installation Kits & Parts

AT A GLANCE

• Oxygen Free Copper
• 17FT Pro Series Dual Twist RCA Cable
• 17FT 8 AWG OFC Power Cable
• 3FT 8 AWG OFC Ground Cable
• 17FT 18 AWG Turn-on Wire
• 1 AGU Fuse Holder with 40 AMP Fuse
• 2 Nickel Plated 8 AWG Seamed Ring Terminals
• Hardware Included

AT A GLANCE

• Hyper-Flex Power Cable
• Insulated Crimp Connectors and Zip Ties Included
• Oxygen-Free Copper Cabling
• Superior Bass Response

AT A GLANCE

• ISO trim rings are provided for a custom looking install
• High impact, OEM quality, ABS plastic construction
• Snap-in ISO mount radio supports hold any ISO style radio

AT A GLANCE

• Radio Replacement Interface for Select non-amplified Class II GM vehicles with 24-pin connector
• Retains all safety warning chimes when the factory radio is replaced
• Provides 10-minute RAP accessory output
• Interface can be quickly updated if needed from PAC website using PAC-UP USB adapter
• Retains all safety warning chimes when the factory radio is replaced
• Provides 10-minute rap accessory output
• 24-Pin connector

AT A GLANCE

• Universal Steering Wheel Control Interface
• Plug and Play installation
• Works with Nearly All Popular Aftermarket Receivers
• Provides Conguration Information for Dip Switch or Direct Flash from PC APP

AT A GLANCE

• ''T''-Harness
• For select 2007-up Nissan/Infiniti push-to-start models

AT A GLANCE

• ''T''-Harness
• For select 2010-up Toyota/Scion standard key models

AT A GLANCE

• Single wire output for steering wheel control module
• Retains all safety warning chimes
• Plug and play interface
• Made for GM Vehicles 2004 and Up w/out Onstar

AT A GLANCE

• Comes with a 70-8113 wiring harness for power
• 204-inches long
• Compatible for: 2003-2006 Toyota 4Runner including Limited, 2005-2006 Toyota Matrix, 2004-2005 Toyota Prius, 2005-2006 Toyota Sequoia, 2004-2006 Toyota Sienna, 2004-2006 Toyota Solara, 2005-2006 Toyota Tacoma, 2004-2006 Toyota Tundra
• Factory Amp Locations: 4Runner inclusing: Behind passenger rear quarter panel, Matrix/Prius: Under passenger front seat, Sequoia: Under center console, Sienna/Solara: Behind glove box, Solara: Behind glove box, Tacoma: On back wall near passenger side, Tundra: On back wall near drivers'' side
• Included components: Wire Harness, Manual
• Features only power wires with no RCA Plugs
• 204" long factory amplifier bypass harness
• Harness is plugged in at the factory amplifier and ran to the location of the aftermarket radio or amplifier

AT A GLANCE

• ISO trim rings are provided for a custom looking install
• High impact, OEM quality, ABS plastic construction
• Snap-in ISO mount radio supports hold any ISO style radio

AT A GLANCE

• Radio Replacement Interface For Select GM Vehicles Without On-Star
• High current 10A accessory output
• Data controlled outputs for connecting to your navigation radio; speed, reverse and E-brake status output wires
• Retains factory installed amplifier
• Data controlled RAP accessory output

AT A GLANCE

• Factory look when complete
• Finest material for good fit and durability
• Instructions and hardware included
• Provides exceptional reliability

AT A GLANCE

• For installing an aftermarket radio
• High impact, OEM quality, ABS plastic construction
• Turbokit radio openings will hold either DIN or ISO DIN units

AT A GLANCE

• Radio Replacement Interface for Select 2005-up MSCAN-bus Ford, Lincoln and Mercury Vehicles
• Enables factory features such as rear seat entertainment, rear controls, and the THXII amp when the factory radio is replaced
• Provides RAP accessory power output, vehicle speed, illumination, reverse indication output and parking brake output signal to allow easy installation of an aftermarket NAV system
• Compatible with THX, SONY, Shaker and Audiophile sound systems in applicable vehicles. (v1.1.4 or higher required)

AT A GLANCE

GMRC-03 Class II data interface for the 1997-2004 Cadillac DeVille, Eldorado and Seville Specifically designed for applicable vehicles noe equipped with OnStar or a factory-amplified system Allows use of factory chime system-chime continues to come from factory front speaker location Supplies 10 amp 12 vollt switched power Critical for use when consumer replaces the factory radio, then later replaces aftermarket amplifiers and speakers

AT A GLANCE

• Provides accessory (12 volt 3 amp)
• Used in non amplified systems or when removing amplified systems
• Retains warning chimes
• USB updatable

AT A GLANCE

• Retains all safety warning chimes
• Provides 10-minute RAP accessory output
• Compatible with all audio system levels
• Amplifier turn-on output wire
• Single wire output for steering wheel control module
• Retains audible turn signal indicators
• Provides illumination wire

AT A GLANCE

• 2010-Up Mazda 2, 2007-Up International Multi Kit
• Din and DDin radio provision
• Painted Matte black to match factory finish

AT A GLANCE

Allows installation of an aftermarket radio using the existing factory wiring and connectors
The XSVI series interface is an inexpensive solution that provides +12-volt accessory power output for select vehicles that data control signals instead of conventional power signals. If the vehicle is equipped with retained accessory power features, the XSVI will keep those features.

AT A GLANCE

• Allows for the installation of both double-DIN stereo or one single-DIN with pocket
• Factory look when complete
• Made of ABS plastic for extra durability
• Drop-in installation

AT A GLANCE

• Uses factory radio brackets for a strong secure mount
• Will accommodate a full DIN unit
• An under radio pocket is included
• Process molding provides factory color and texture match

AT A GLANCE

• Provides accessory (12 volt 10 amp)
• Retains R.A.P. (retained accessory power)
• Used in non-amplified systems, or when replacing amplified system
• Provides NAV outputs (parking brake, reverse, and V.S.S.)
• Prewired ASWC-1 harness included (ASWC-1 sold separately)
• High level speaker input
• USB updatable
  
  

  APPLICATIONS

  • Chrysler
  • 200: 2011-up
  • 300: 2008-2010
  • Aspen: 2008-2009
  • Sebring: 2007-2010
  • Town&Country: 2008-up
    
    
  • Dodge
  • Avenger: 2008-up
  • Caliber: 2009-2012
  • Challenger: 2008-2010
  • Charger: 2008-2010
  • Dakota: 2008-2011
  • Durango: 2008-2013
  • Grand Caravan: 2008-up
  • Journey: 2009-2010
  • Magnum: 2008-2009
  • Nitro: 2007-2011
  • Ram 1500: 2009-2011
  • Ram 2500/3500: 2010-2011
  • Ram Chassis Cab: 2011
    
    
  • Jeep
  • Commander: 2008-2010
  • Compass: 2009-up
  • Grand Cherokee: 2008-2013
  • Liberty: 2008-2012
  • Patriot: 2009-up
  • Wrangler: 2007-up
    
    
  • Mitsubishi
  • Raider: 2008-2009
    
    
  • Ram
  • 1500/2500/3500: 2012
  • Chassis Cab 3500/4500/5500: 2012
  • C/V Tradesman: 2012-up
    
    
  • Volkswagen
  • Roufan: 2009-2013

AT A GLANCE

• 07-Up Ford Lincoln Mercury Select Models
• Retains R.A.P. If Equipped / Provides harness for ASWC
• Provides Navigation Outputs / Provides Subwoofer Retention
• USB Updatable

AT A GLANCE

• ''T''-Harness
• For select 2004-up Nissan/Infiniti standard key models